How to Use a Rapid Splitter

Before using the Rapid Splitter, you should lea how to properly install the cable holder and how to remove it. These two tools are essential to the operation of the Rapid Splitter. To install the cable holder, you must first remove the bolts on the cable holder. Next, you must remove the locking collar from the Rapid Splitter  HV cable and then remove the B+ cable. The same procedure is followed for the B+ cable. To remove the wheel arch liner, push the clip forward and loosen the nuts.

Once the Rapid Splitter is coected to the battery, it must have a safety waing at the begiing. The waing should mention the risks of using the charger. The on-board charger links to the high-voltage battery through the Rapid Splitter. This device is typically located beneath the rear seat. It is made from durable plastic and can withstand up to 4,000-voltage surges. If you want to charge your Rapid Splitter on the road, make sure to include the proper components.

The Rapid Splitter comes with a battery. The battery needs approximately six to eight hours to fully charge. A two-amp charger should be used for this purpose. In case of battery problems, you must first discoect the Battery and then charge it using a power source that can support its charge. Then, discoect the Power Source from the Rapid Splitter. If you need a new battery, you can buy one directly from the company. This way, you can make sure that your Rapid Splitter is safe to use for a long time.

The flywheel log splitter uses a flywheel system that helps it achieve speeds six times faster than a traditional 22-ton hydraulic splitter.  it is also very lightweight, making it convenient to use indoors as well as outdoors. The can also split large logs.

It is important to always read the instructions for use on your Rapid Splitter to avoid any possible hazard. If you are using it in a forest, you must have a spark arrester installed on it. Otherwise, you may break the law if you use it on US Forest Lands. This can also be a violation of other state and federal regulations. If you are not careful, you could end up in a criminal case.

Another good choice is the Fast Fire kinetic splitter. It is an electric kinetic log splitter that outsplits a 22-ton hydraulic splitter. Its twin 55-pound flywheels provide sufficient energy to quickly split even the toughest logs. Another great feature is the automatic belt tension system. This eliminates the hassle of belt tension. The Fast Fire splitter is capable of splitting logs up to 520mm in length and 400mm in width.